Were going in!!

Coles_55

New member
Joined
Dec 5, 2005
Messages
1,227
Age
39
Location
Eagle, WI
Well I dont know if this is a good idea especially when theres a good amount of snow on the ground but im hoping it wont talk me too long. Heres the plan:

New track, 1" Camoplast Hacksaw, heck of a deal on this 330.00.
New slides, blue ones!!! 10.00
New bushings and slides for the shocks in the skid
Maxx Perf. thinner head gasket .6 MM 35.00
Pilot Jets for the new gasket
Maxx Perf. Clutch kit 162.00

All this is going on my 96 600Xt and I am kinda pressed for time because I am supposed to be going up north this weekend. I have all the parts except for the Maxx Perf stuff, that left today. The skid is already out, and I was wondering what other doo dads and stuff I should be looking for when I do this. This will be my first new track install so if you all have any pointers or little short cuts that would be great.

I figure I will get the new track and slides and bushings in by this weekend only because the other stuff wont be here in time. I figure I will do that stuff next week.

So pointers and a great how to would be GREAT!!

Thanks guys!!
 
i would replace the speedo side driveshaft bearing while you are in there as well, especially if you have never cleaned/repacked it.
 
Ok will check that also, I have the service manual so I will probably get a new one. ANything else??
 


Back
Top