VMAX ripsaw question

[kinger156]

I just bought a 1.25 Ripsaw and am going to put it in. Do I need smaller idler wheels also or will the track fit in the tunnel OK? I'm already have the bearings to PM during the change.

 

[yamaholic22]

if you aren't studding you can run the 9 tooth drivers. Track will rub on the heat exchanger protectors for awhile, but it will eventually wear in, or you can clip the track in the spots that rub. You dont need smaller idler wheels anywhere, i'm assuming you were referring to the carrier wheels up top that carry the track back over the suspension to the drivers? They are fine with bigger tracks, run it.

 

[kinger156]

Thanks. Yes I was referring to the carrier wheels up top. Not a stud user so no problem with those.