Dfunkdf
New member
I have a 01 700 sxr and it has a low end bog i ran it without air box ( i didn't ride it though) and it sprays gas back out of the carb until the rpms get up and then it stops any help thanks
how old are the reeds in it?
TJ500
Member
the airbox creates a low pressure area at intake... with it installed, there will be less spraying of premix out of the carbs....
Dfunkdf
New member
Maim said:how old are the reeds in it?
the reeds have like 1000 miles on them they looked fine i'm haveing a low end bogg bad
yamaholic22
Active member
probably dirty pilots. Get in there and clean those carbs good.
Dfunkdf
New member
It's only one carb doing it and i already cleaned the pilots
Check the reeds again.
Dfunkdf
New member
Ding said:Check the reeds again.
What should i be looking for, they are seated on the cages (no gaps or hole in them) thanks for the help
do these 2 things first
Have you REMOVED the reed block from the engine and held it up and looked to see if you can see light around the edges?
have you put a compression guage on all 3 cylinders?
the reason I ask is sometimes if you simply stick a ring in 1 cylinder, it will have excessive leak down and cause the exact problem you describe. will run fine at mid and high rpm, but low end is boggy.
Have you REMOVED the reed block from the engine and held it up and looked to see if you can see light around the edges?
have you put a compression guage on all 3 cylinders?
the reason I ask is sometimes if you simply stick a ring in 1 cylinder, it will have excessive leak down and cause the exact problem you describe. will run fine at mid and high rpm, but low end is boggy.
Dfunkdf
New member
mid sucks to but high is unreallly thanks
Dfunkdf
New member
mrviper700 said:Have you REMOVED the reed block from the engine and held it up and looked to see if you can see light around the edges?
have you put a compression guage on all 3 cylinders?
the reason I ask is sometimes if you simply stick a ring in 1 cylinder, it will have excessive leak down and cause the exact problem you describe. will run fine at mid and high rpm, but low end is boggy.
yes i have there is no light between the reeds and the reed block