fastassyamaha
Member
Would i run in to any problems with a 1.25 inch track with studs on my 97 vmax??
change_up
New member
There is a bit of controversy over this. Many people believe you have to change to 8 tooth drivers too get enough clearance from the heat exchanger to the stud. Some have made it alright with 9 tooth... but personally, I would go to 8 tooth and re-gear for the changed ratio.
fastassyamaha
Member
thanks whats the biggest lug you can go with out studds
jmp2204
Member
I actually logged on tonight to find out some opinions to i problem i snagged tonight.Ibought a 97 sx 2 years ago from a dealer near where i live and he through in a 1" kimpex sno x track with the deal.being very busy the last couple years (little ones) i've only rode about 500 miles .this year in anticipation of getting back to doing some serious riding again i decided to install the track.well all was good til i went to rotate to tighten the set screws(bearing collar) the track would not move (heat exch protectors) got them off scrubs on the tunnel and the heat exchanger. this a 1" lug what now?fastassyamaha said: