jmp2204
Member
i did the reed notch and while apart pulled the bowls ,it's got 141.3 accross the board thats 2 sizes down from std,whats everybody runnin for mj's ? do i need to rejet for the reed notches?
What elevation are you at. Sounds lean fro sea level. Maxdlx
jmp2204
Member
sea level or around sealevel same as watertown ny but i don't know exactly.always usually jet at standard setting unless the sled is running rich or i know i won't be doing extended runs at w.o.t.,i've been out of the the game for a while and i'm not up to snuff on this sled (updates ) thanks for your help
yamyrider
Active member
thats way too lean.
SX700R RIDER
New member
- Joined
- Nov 13, 2004
- Messages
- 33
141.3 sounds lean to me. On A stock machine 142.5 accross the board is about as low as you should Go safely.It will also be fine with reed notch.
Last edited:
change_up
New member
How are your plugs and piston wash? My 600 was jetted down about 2 sizes for somewhere around sea level. Stock is: PTO: 136.8, Ctr/Mag: 133.8. I was running 133.8, and 131.3's. Just check your plugs and if they look good you should be o.k. I may go a little bigger on the PTO side if it were me though.
I have some 142, and 143.8s if you need them Paul