Jetting chart for 01 SXR700?

[Yama49601]

Hey does anyone have a link to a jetting chart for one of these? I looked around and didn't find one.

Thanks a lot.

 

[01sxr700]

This is from my 01 manual

Sorry for the quality but due to the attachment size restriction this is the best that I could do.

If u want 2 pm me I will sent u a higher quality pic.

 

[yamyrider]

the jetting is on the tech page in specs section.
Do you want to change your jetting or just want to know what it is.

 

[Yama49601]

Well it was acting like it was loading up at part throttle. Then I did the silencer mod and it seemed to make it a little better. But I lowered the needles now to 2.5 and I was just curious what the chart says the temp range would be for that setting. I think having them on 3 was too rich but it hasn't been real cold here either any time I've had some time to get out and ride it. It's running great now though and I got the 1.5" Ripsaw installed tonight

 

[Yama49601]

Oh thanks for posting that too 01sxr700. I've seen two different copies of that now and have another question for you guys about the carbs. My needles don't have 3 positions they have 5???

 

[yamyrider]

that is correct 5 positions.....the #3 is the factory position the needles come set to.
Kepp and close watch on your plugs and piston wash, make sure you are not too lean.

 

[Yama49601]

Ok, I just wanted to make sure it was the right chart since it shows 3 clip positions instead of 5.