Yama49601
New member
Can someone please tell me something about putting these rivets in? Do they have to be perfect when they are pounded down or flattened? I'm asking because I finally got everything to get my clutch switched over to the 51/43 helix with a 4.5 gram center rivet. I put the rivets in the other night but I just pounded them down with a hammer and they didn't all end up flattened the same. The first one I did flattened more toward the tip than the other two (I apparently had the hammer angled 
). Should I re-do them and faltten them in a vice instead? Or is there a better way? I really don't want to leave them the way they are if it's gonna screw something up. Especially when they're so cheap anyway.
Thanks a lot.
). Should I re-do them and faltten them in a vice instead? Or is there a better way? I really don't want to leave them the way they are if it's gonna screw something up. Especially when they're so cheap anyway.Thanks a lot.
Waterfoul
New member
As long as they don't interfere with the swinging of the weight and they are tight they should be fine.