Concept Carbon
New member
ok i just noticed a big chunk is missing out of the outer primary sheeve about 1/4 by3/8 between the set of 2 bolts that holds the cover on. I guess i bottomed out some where it looks like it was hit with a hammer.
Anyway, my buddy has a spare primary from a 2004 rs vector will it fit my 97sx700.
Anyway, my buddy has a spare primary from a 2004 rs vector will it fit my 97sx700.
ragerider
Member
It will fit but use your spring and weights
Your gonna have to use your old primary cover, spring, & weights. Rollers will be close. I have a good primary off a 700 sx for sale. pm me at
brodam@westman.wave.ca
$200 CDN. shipped from Manitoba. Comes complete with everything except weights.
brodam@westman.wave.ca
$200 CDN. shipped from Manitoba. Comes complete with everything except weights.
Concept Carbon
New member
cool thanks guys you rock...
Im gona try it the with the vector setup for fun. Then il swap the spring cover and wieghts. (my weights arnt stock, i shift at 4800 and 9100 so maybe it will be better)
what would happen if i left the vector setup
Im gona try it the with the vector setup for fun. Then il swap the spring cover and wieghts. (my weights arnt stock, i shift at 4800 and 9100 so maybe it will be better)
what would happen if i left the vector setup
With the Vector set up you will rev about 7000rpm on a good day.
Concept Carbon
New member
lol, thansk turk you rock, hey it would be good on gas.
heres a pic of the damage, i may take you up on your offer, il let you know this week.
Do you think i could just clean up the chip so that it wont crack in the future.
I think i already did about 200kms the way it is.
heres a pic of the damage, i may take you up on your offer, il let you know this week.
Do you think i could just clean up the chip so that it wont crack in the future.
I think i already did about 200kms the way it is.
That moveable shive is ruined. It will further break causing a lot more destruction & possibly taking out a crank seal & totally destroying your motor....your call!
Concept Carbon
New member
would it work if i machined the same amount off each side
My bud has his machined right there to help cool the clutches & lessen belt dust. It failed & caused mass destruction due to the fact it loses structural integrity. You really wanna save $20 now & spend way more later. Sold my clutch so I ain,t making a sales pitch!
Concept Carbon
New member
Turk said:
wow thanks for the info, ya i dont think ill risk it, $200 now is better then $500 tommorrow plus a hole in my cab.
Thanks for all the help
Jay, ps. i may be able to buy a vector clutch tommorrow, but if not will you have one avialable on monday.