95-vmax
New member
- Joined
- Jan 23, 2006
- Messages
- 24
I'm looking for the specs/setup for the carbs with PSI twin pipes on a 95 VMAX LE 600..
I bought the sled used.. this is what is in there..
155 MJ
Neddle set at 1.5..
air screw between 1.75 and 2.00 out
IT was sluggest off the line and didn't move til 5800 rpm
maxs out at 7500-7600 rpm..
I changed the neddle to 2.5 (stock is 2) noitced big time response down low but still sluggest til 5800 rpm.. the motor changes tone also at 5800 rpm..
maxs out at 7500-7600 rpm..
I can go to a 157.5, 160, 162.5, 165
so i got bigger on the pilot jet also?? or turn in the air screw??
Let me know
thanks
I bought the sled used.. this is what is in there..
155 MJ
Neddle set at 1.5..
air screw between 1.75 and 2.00 out
IT was sluggest off the line and didn't move til 5800 rpm
maxs out at 7500-7600 rpm..
I changed the neddle to 2.5 (stock is 2) noitced big time response down low but still sluggest til 5800 rpm.. the motor changes tone also at 5800 rpm..
maxs out at 7500-7600 rpm..
I can go to a 157.5, 160, 162.5, 165
so i got bigger on the pilot jet also?? or turn in the air screw??
Let me know
thanks
I had psi 's on my 94 600, same motor, all i did was lower the needles one clip pos! everthing else was left at stock! It screamed ....stayed right w/ alot of 700's of the time. make sure your rollers are good... it eats them ,