I cant seem to hold the rpm up on longer runs. when i nail it ,it goes to 9 grand ,right where i should be ,but after 1000 ft she starts to fall off and continues till its down to 8300. will the bigger rollers help... maybe lower sec. setting? runnin slp pipes w/ 8ca's w/ alum. rivits in both holes, 14.5 rollers ,80* on sec.on my 700sx. When i had the 15mm rollers in and one rivit in weights ,she would peg out to 9400 and stay there,( too high,) shes gettin real finickey
yamaholic22
Active member
taking weight out of the tips and/or use a lower finish angle