14.5 mm rollers with heelclicker kit?

SNOWRULES

SNOWRULES

New member
Joined
Dec 18, 2005
Messages
361
Age
40
Location
Ottawa. Ontario, Canada
have a 2000 sxr700 that i'm about to put PSI tripple pipes on and a heelclicker primary kit. right now i'm running it with 14.5 mm rollers as per turks tuning tips on the tech pages. just want to know if i can use the same rollers when i put my heelclicker kit on or if i should go back to the stock rollers. i just heard that the heel kits can blow up the 14.5 mm rollers. anybody have any input? :die:
 
you simply can not hook up with 14.5 rollers, it will explode with power down low and I dont care what track, what amount of studs, you wont be able to keep it from trenching and spinning, and then overshifting. It also will not let you run any weight in the weights, which pretty much makes them useless.
 
ok so the stock rollers are my best bet. any tips on jetting and clutching with PSI pipes with heelclickers? i currently have stock .92 track, 144 studs, maxx performance transfer rods, one layer removed from head, stock secondary clutch, reed spacers and currently jetted one size down on mains, one size down on pilots and a half needle clip leaner. jetting i can do just gonna go 2 or 3 sizes up on mains see where i'm at and adjust from there. mostly concerned about the clutch kit and where to start with that any tips would be great mr. viper. thanks.
 
I would try 15.6 rollers, red spring, 4-5 grams in the heel, 4 grams center hole and empty tip
 
You must log in or register to reply here.


Back
Top