Mac
Member
I'm replacing 2 bad bearings on both wheels on the upper shaft that holds the track up. The large wheels. It appears as though they must be pressed out. How are you guys replacing these bearings?
JERSEYJOE said:Bob: I just did these last weekend. Remove the circlip, then I take one of the bolts that holds the suspension in the chassis and thread it back into the shaft. This way I can beat it with a hammer and not hurt the shaft. The idler will be forced against the bar and come off. the I pull the shaft out the other side and do the same thing in the vise. Remember that you will flatten the bolt head so I use an old one