Edge skid in a RX1...DONE!

[kinger]

Check out this link:

http://www.ty4stroke.com/viewtopic.php?p=332236#332236

Thanks to n2roic, johhnysrx, and clharris for helping with my questions. The install went ok, if I had to do it again like anything it would take about half the time.


Took it out for a ride and its awesome. Need to fine tune some adjustments but so far I think its a winner!

 

[n2oiroc]

good choice. a lot cheaper than an expert or m10 and they work great.

 

[kinger]

Updated the 4 stroke link, to any furture searchers installers, make sure to install the skid Level from the top of the tunnel for the front and rear mounts. I had mine tipped up 1" hoping to get some more clearance for my studs and it would bottom out and stay there! Also for the RX1 don't even try stock springs get the HD ones right away, thought I could make mine work and its so close but I just don't think they are going to cut it. (I'm 225 lbs and muffler in sled is 28lbs, etc you get the point a lot of weight back there)