700SX Grip Removal

[kcp]

Hi Guys,

I have to replace the throttle block and was wondering if this can be done with out removing the grip. I found a post about this when I did a search but it was not for an SX. If I do have to remove the grip will the grip slide off when the rivet is drilled out?

Thanks

 

[Tod]

If you have to remove the grip............. drill out the rivit and then use air pressure to blow it off.

A good blow does wonders...........

Tod

 

[daman]

If i remember right grip has to come off..

 

[kcp]

Its Done

thanks for the replys guys. I ended up drilling out the rivet to remove the grip which was not difficult at all. I did not use air to take off the grip; I ended up just pulling it off. So I guess you could say it was a hand job instead of a blow job .

 

[daman]

thanks for the replys guys. I ended up drilling out the rivet to remove the grip which was not difficult at all. I did not use air to take off the grip; I ended up just pulling it off. So I guess you could say it was a hand job instead of a blow job .

Yea mine also came right off when i poped the rivet off..