viper pv adjustment question how do you do it.

Concept Carbon

Concept Carbon

New member
Joined
Jan 31, 2006
Messages
1,188
Age
45
Location
Ottawa, ON.
ok im going to adjust my pvs tommorrow, from what ive read you run your idle down to 900 and adjust them for 2.5mm. so i loosen the 2 alens the measure 2.5mm with a dial caliper.

just wanted to double check im doin gthis write before i mess something up.

thanks.

also feel free to post your methods of doing this.
 
Use two 2.5mm allen wrenches as a gauge

also did you search this.LOTS of info. lol
 
Last edited:
yeah i seached like crazzy but i get alot of srx info, and jsut wanted to double check, also there is almost to much info to sif tthrough thought it would be easyier to just ask.

thanks so 2.5 is good for a viper.

lol searched but never even noticed the post lik e3 below this one, whenever i search i get cleaning methods.
 
Last edited:
question for you guys, I see that you can adjust your valves by measuring 2.5 mm gap, and can also measure by feeling in the exhaust port to make sure they are flush. Whats the diffrence here, does the 2.5 mm measure how much tention is on the cable?To do it either way you have to adjust them from the servo..so is it good to do it both ways to make sure cable tention and valve adjustment is correct?
 
im goin gto do what yamaha and mr viper recomend which is measure 2.5mm, check about 3 posts below they go into detail there.
 
EricMichael said:
so is it good to do it both ways to make sure cable tention and valve adjustment is correct?
Click to expand...
You could,it's all up to what you want to do,i'm still undecided.

i may do the yamaha way then pull pipes and see how far off they are..
 
You must log in or register to reply here.


Back
Top