Hey Guys, Im looking for some input here. Im going with turks setup for clutching my 01 srx. The setup calls for 4.5 rivits in the outer holes. What are the rivits in there now and do I need to change them? If so is there any trick to removing the rivits and putting the new rivits back in? I was just looking at the weights and the rivits kinda look the same as the new ones I got. Thanks John
Clutching help
- Thread starter Johnnysrx
- Start date
marty f
New member
i believe those ar 3.5 g
marty f
New member
Setup
If You Are Running Turks 48/40 Green Spring The 4.5 Needs To Be On The Inside Closest To The Pin
If You Are Running Turks 48/40 Green Spring The 4.5 Needs To Be On The Inside Closest To The Pin
2ooosrx
VIP Member
- Joined
- Oct 2, 2004
- Messages
- 2,414
- Age
- 36
- Location
- Gurnee, Illinois
- Website
- www.cbperformanceparts.com
stock is 4.5 outer and 3.6 inner
Bruce
Bruce
Rambunctious
New member
one is gold ( 4.5g?) the other lighter one is silver?
the easiest way to remove is take a drill bit smaller than the hole ( which is even smaller than the peened over head of the rivit) and drill the rivit head
about 1/8 or 1/16" deep
then take a small punch and hammer and punch out the rivit.
install the new one and pound like you know what to peen the head over. make sure it is tight( no slop) as the clearance on the clutch spider is tight around the swing weights.
Ramb
the easiest way to remove is take a drill bit smaller than the hole ( which is even smaller than the peened over head of the rivit) and drill the rivit head
about 1/8 or 1/16" deep
then take a small punch and hammer and punch out the rivit.
install the new one and pound like you know what to peen the head over. make sure it is tight( no slop) as the clearance on the clutch spider is tight around the swing weights.
Ramb