maximus070301
New member
I just put in a new ad bovinzx2 136" on a 02 viper this weekend i used a 1.5" intense track with 8" drivers,the only problem is that the track rubs a little on the protection bars of the front heat exchanger,can these bars be cut off or does anyone have another suggestion.Or can i just let the track were down a little?
davessrx
New member
Mine are cut off on my SRX with 9 tooth drivers and 1.25 track. I didn't install it and it has been ok so far.....about 2k miles.
redsnake3
New member
yes you can easily remove the coolant protectors. it makes for alot more clearance. dont even need 8 tooth drivers with them removed. your all set to clear 1.75" with them removed. just dont remove them if studs are a plan.
RIVERRUNNER
Active member
Yep I removed mine last year when I put on 1.25 ripsaw. Just don't do the stud thing!!!!
maximus070301
New member
is there any tricks in removing them?did you just cut the welds?Thanks for the info
redsnake3
New member
no tricks, like you said just cut off the welds.
maximus070301
New member
sounds good thanks