installing extrovert drivers on a 98 SRX

[MSRXRider]

So I finally got around to installing the anti-ratchet drivers on my SRX. Problem is how far do the drivers go from each end of the axle? Somebody has to know other then the Yamaha shop. Thanks

 

[richierich]

2 1/2" from clutch side end of shaft to outside of driver shaft.

5 5/16 from splined end to outside of driver shaft.

you'll want 9" center from center to center of driver teeth.hope that helps u.

 

[MSRXRider]

Well I must have them all messed up. Does it matter how they go on the shaft? Do the teeth that go inside the track face out or in?

 

[richierich]

i dont understand what your saying.the drivers should have ( teeth) on both sides and around the diameter of sprocket also.there are timing mark arrows on sprockets that you need to have lined up.i guess i should asked what brand you have.

 

[MSRXRider]

This is what I'm working with. I think I put them on back words. Arrows are lined up. the drivers are cycle works extroverts

 

[M-Max]

I think you need to run your stock or same size external driver.
I just installed some Wahl extroverts, they have the drive cogs on both sides.
I got my Wahls from Hartman. I think they were about 150.
Someone here may have a better price.

 

[MSRXRider]

These are the same ones that on my 99 Mtn Max. I have no trouble with them. Besides the used track I bought the inner cogs that the stock drives run on are tore up so I have to go with anti ratchets.

 

[M-Max]

if the inner track lobes are torn up I would switch those around for sure.

 

[MSRXRider]

true. now I just to need to know how far each sprocket is from each end of the axle shaft.

 

[M-Max]

I have the sheet at home. If no-one posts the mesurements by the time I get home I will post them.

 

[MSRXRider]

Got it figured out. thanks for the help.