I know that if I swap the stock skis on an SX chassis for Viper ski’s I am going to drop the front ride height of the sled about a ½” because of where the pivot point of the Viper ski saddle is located relative to the SX ski saddle.
I am assuming from this information that the spindles on a Viper are thus a ½” longer than those on an SX chassi. So, if Viper trailing arms fit on an SX chassis would I then raise the front ride height a ½” if I still use the SX ski's? Does anyone have any info on this? Would I need to change the upper/lower control arms and radius rods as well?
Mills
I am assuming from this information that the spindles on a Viper are thus a ½” longer than those on an SX chassi. So, if Viper trailing arms fit on an SX chassis would I then raise the front ride height a ½” if I still use the SX ski's? Does anyone have any info on this? Would I need to change the upper/lower control arms and radius rods as well?
Mills
anyone?