SLED = 1994 VMAX 600
Hi everyone,
As per the general concensus, I have dropped my carb pin 1 position in hopes of getting beter mid-range power. By this I mean I have moved the matal c-clip up 1 groove thus dropping the pin 1 position. There were (2) nylon washers under the c-clip and I wanted to make sure that what everyone calls 1 position doesnt mean removing one of the washers.
Thanks in advance
Jedrow
Hi everyone,
As per the general concensus, I have dropped my carb pin 1 position in hopes of getting beter mid-range power. By this I mean I have moved the matal c-clip up 1 groove thus dropping the pin 1 position. There were (2) nylon washers under the c-clip and I wanted to make sure that what everyone calls 1 position doesnt mean removing one of the washers.
Thanks in advance
Jedrow
..SNAKEBIT..
VIP Member
move clip1 position and keep washer in same place = one position
if you move a washer you can get 1/2 a position
if you move a washer you can get 1/2 a position