Concept Carbon
New member
maximum perf oilite clutch cover bushing install??
so i just got my bronze max perf clutch cover bushing. It sez to aply a thin coat of green loctite, if i cant find any can i use blue.
Also the bushing has a 1/16" tapper groove on one side. so which way do i press the old one out.
thanks Jay
so i just got my bronze max perf clutch cover bushing. It sez to aply a thin coat of green loctite, if i cant find any can i use blue.
Also the bushing has a 1/16" tapper groove on one side. so which way do i press the old one out.
thanks Jay
Last edited:
Concept Carbon
New member
im guessing i press it out from the backside
I used red, blue will never hold!
Concept Carbon
New member
had some green at work it, pressed the old bushing out from the backside
i hate green loctite
Concept Carbon
New member
bushing was a pita it woudlnt fit on the shaft after, so i had to use a reamer. but besides that much better then stock imo actually durable.
Danger Dog
Member
That bushing is a waste of time and money. I put one in and it lasted a short time and the cover was rattling again. just my .02.