Yamidude59
New member
Well i noticed that the right rear of the seat was a little loose so i opened up the rear seat pocket and tightened the right nut (looking at the sled from the rear) so i tightened it, it DID tighten the board that holds it down to the tunnel, but i noticed the plastic housing which is what that pocket is made out of is crack around where the nut is, so even though i have the nut tight, the pocket compartment is still wiggly somewhat, nothing major, but it might get worse and i was wondering what i can do to fix this.... I'm meticulous with my sled, and want things perfect, this will now eat at me until i find a solution.... 
Dave M
New member
Super Glue..
Yamidude59
New member
I was thinking of a more permanent fix, is this a common failure point in the seat? do they even make seats for the srx anymore? seat is mint other then that area.....
Yamidude59
New member
i was thinking of making a bracket that goes inside the rear pocket on the bottom that extends to both ends where the bolts are and that should do it....
YAMAHIZAL700
New member
couldnt you use a large washer to hold down firmly on the plastic?
Yamidude59
New member
does this happen alot in the rear of seat? its nothing major.... probably will try the washer thing, see if i can get one big enough that will work....