Question about srx heads- When I bought the sled (98 SRX)the heads on it had been cut too much by the previous owner, had way too much compression (180 psi), so I bought a new set of stock heads. I noticed on the old ones the numbers on them are 8dn00/062 on the pto side and 8dn00/061 on the other two cyls. my new heads are 8dn00/062 on all three. is there a difference? should I still jet the pto cyl richer than the others?
thanks for your time.
thanks for your time.
bajardine
New member
srx heads
It's my understanding that the 8dn-00 is the part number for the SRX heads up to 1999. The newer ones, 2000-02 are 8dn-10. The last part of the number you mentioned are a casting or mold number to show what mold was used. I've just read this in another post.
Bruce
It's my understanding that the 8dn-00 is the part number for the SRX heads up to 1999. The newer ones, 2000-02 are 8dn-10. The last part of the number you mentioned are a casting or mold number to show what mold was used. I've just read this in another post.
Bruce
harness racer
New member
Just Like Bajerdine Said .....