valin
Active member
Well, I was bored, so I did some measuring, and the SRX 700 engine base is just a hair wider than the Vmax540 base. The motor will fit in there with ease, however, the pipes will be a difficult fit, and the Mag carburetor is going to run right into a vertical frame support. A bit of modification will have to be done there. Other than that, It looks as though it would be a fairly easy job. I think the rad might have to go to fit the pipes.
Decisions, decisions.......
leave it alone as a 540, or go with a well ported 780, 40.5mm bored mach z carbs with filters, severely modified stock pipes, srx clutches, jackshaft, chaincase, driveshaft and a different skid?
The sled will look 100% origional when I am finished.
Decisions, decisions.......
leave it alone as a 540, or go with a well ported 780, 40.5mm bored mach z carbs with filters, severely modified stock pipes, srx clutches, jackshaft, chaincase, driveshaft and a different skid?
The sled will look 100% origional when I am finished.