boost bottle question again

YA*AM*A*HEAD

New member
Joined
Nov 23, 2007
Messages
1,316
Age
45
Location
indiana
ok guys i am putting a boost bottle on a srx ...read every post about it ...i have ran into clearence issues while doing this ...and i belive i bought someone elses problem with out being told about it ......i see i need to flip the thors switch around on the rack ....but the carb boots seem too big the carbs dont fit tight like the old ones ....and might fall off while riding ...and after reading i think it might not do any good on a srx except make it harder to get hands down there
 
i did.i bought them here and wasnt told he had the same problem with them so that was the reason for selling ...the boots are the wrong size ...i beive they are from a doo or poo or something ....the reason i say that is cause they have a hole in the bottom of the boot for a primer or something .....so i aint wasting my time with it ...just my money ......
 
i told you in a previous post not to run one.i believe i did anyways.hate to say it but i told you so.no im only playing with you but i hope you didnt spend too much on it.
 
lol i thought about selling it ...but i would tell the person the problems i had with it ...i wasted a few hours of my time and the 100 bucks for it and than i had to buy heli coils to rethread the holes ..another 40 bucks wasted ....
 
you have to use 500 twin boots with the boost bottle.The have the holes all ready becaue the 500 had a boost bottle stock.
 


Back
Top