do u think i can put studd on a 1 inch ripsaw and how tall and how mutch... do u think 96 its enough for trail and lake race at constance bay.... 

Triple X
New member
Sure you can stud a 1 inch ripsaw. With a one inch track most people use a 1.080 but you can also use a 1.175 I wouldn't go any taller, as for the number if you are going to lake race on hard packed snow 144, if glare ice 192. I like to put 144 trail studs in for trail riding or hard packed lake running and then for glare ice I through in 48 chisels for a total of 192.
well i doesnt wanna put studd on the side so not sure how mutch in middle.. i just wanna put the minimum studd has possible and no chisels they don't really like crossing road
Triple X
New member
You can put 144 down the middle even 168. On my Apex with 1.25 ripsaw I only run 96 down the middle, works good on everything but glare ice. If you read my post closely I said 144 for trail riding and hard packed lake running (SRX700) and when I do some lake racing on glare ice then I throw in the chisles. Yes, chisles and any stud for that matter does not like road crossings.


2ooosrx
VIP Member
- Joined
- Oct 2, 2004
- Messages
- 2,414
- Age
- 36
- Location
- Gurnee, Illinois
- Website
- www.cbperformanceparts.com
Throw in 144 carbide tipped studs down the center belt of the track and you will be a happy camper. 1.175" is normally a good length for a decent mix between performance and durability. Let me know if you have any other questions.
where is the best place to buy studd ???


2ooosrx
VIP Member
- Joined
- Oct 2, 2004
- Messages
- 2,414
- Age
- 36
- Location
- Gurnee, Illinois
- Website
- www.cbperformanceparts.com
We sell studs give us a call or look on line, the new site will be up by 9/12/08, the end of this week.
Bruce
Bruce