how to take the rest of my track off??

[hickey's got a yami]

yea i know) i got the track hanging and the shaft is still in. do i take the set screws out of the pto side?? or do i take the spedo gear and stuff out too? and can i use 1.175 studs without taking the protecters out??

 

[viper7mi]

Check out the tec page information on track install.

 

[valin]

-Loosen off the set screws on the driveshaft bearing.
-Remove the 3 bolts holding on the speedo housing, pull off the housing, and remove the bearing from the driveshaft.
-Completely take apart the chaincase and remove the brake caliper.
-Either pull the chaincase as far from the bulkhead as you can, or remove it completely.
-Now you should be able to remove the shaft.

 

[pro116]

yes you can use up to 1.25" studs

 

[valin]

yup, I used to run 1.25" chisels on a .725" track

 

[Madmatt]

Utility knife?

That would be the easiest way to get it the rest of the way off.....but it really won't help you much with putting the new one on!

Madmatt

 

[Mysledblows]

^^^^^^^

That's one way to do it. Reinstallation would be a bit tough. I wonder if you could sew it back together with some super fish line?? Make for easy track changes:-)

 

[hickey's got a yami]

thank you guys alot!! thats the rest of my project for this weekend. im kinda wondering what kind of sled ill have when im done. im puting a 1" track with 1.175 on clutch comes after track. i cant wait for snow or at least grass drags. thanks again guys!!!

 

[hickey's got a yami]

i just went on the tech page thanks guys