I bought a unused set of power inc triple pipes for my 98xtc700 from a vendor at the epping grass drags.They were missing the set up instructions,mag spring bracket,and springs.The part #on box is paw-2383 97-99sx race pipes.The pipes i have look like the ones on the tech page but the instructions on the tech page say for paw-3028.Can i use the jetting/clutch setup on the tech page or is there a different setup for these pipes. Thanks for any info chris
grapeape
New member
Are they center dump or end dump (expansion chambers)
Those are awesome pipes. Run 47.5 pilots, 147.5 mains & raise needles 1/2 right across. Run premium fuel & clutch the sled to run at 84-8500 rpm.
Grape ape i believe they are end dumps. The chambers end about 4" from the end of the header tube.The guy wanted $400 and i got them for $350 so i figured i got a good deal on them.grapeape said:
Thanks turk. Would my 8ca's and 50/42 helix work for a clutch set up?
That set up would work well. Try starting with about 3.6 grams tip & .8 in the 1st hole. That should get ya close.
SRX7
New member
great pipes