pt#'s for oversize idler wheels 5.350 or 5.375

[hotrodd]

Anyone have any part numbers for ordering these from polaris or doo? I believe the stock yamaha idler wheels have a 20mm I.D. and all the doo and polaris wheels have a 25 MM I.D. Does this make a difference? I would like to run 5 3/8 polaris wheel or the 3.375 doo wheel.

Thanks

 

[hotrodd]

I did find a polaris wheel that I think will fit - 5.350 O.D. X .750 D.I. - will this be a direct fit for my yamaha? Thanks

 

[blue who]

Big wheels

Boy that was fast in case you did not no you switch the inside retainers from your tamy wheel to the polaris.

 

[ecopter]

I just ordered four wheels from J.R. Graham: 5.375 x .750.

These are the standard ones used on the Indy's from '83 to '02 that will fit the Yami's. I'll let you know how they work as I should be receiving them in a few days.

Jon

 

[MrSled]

Those will fit the outside rail wheels , then you wont need the spacers....But I think the inner wheels will run the normal 25mm ID bearing......

 

[yammiman]

why not just get oversized wheels from Maxx Perf or one of the other aftermarket people? - that is what I'm running and they work awesome - 3000 miles on one set of hyfax!

 

[sxray]

the problem with the maxx wheels are the bearings are molded in and when bearing goes bad or starts getting loose in wheel it can't be replaced. i run the blue kimpex 5.35 and they seem to be working out well.

 

[yammiman]

I've run them on three sleds for a total of probably 7000 miles - never had one go bad

 

[actionjack]

Was planning to order yellow Kimpex myself. good to hear good experience. y-man did you replace all 6 or just the 4 up front?

 

[yammiman]

I replaced all six plus I added the additional wheel on the curve - nothing but good to say about it