Im looking for some help clutching my 02 viper w/ SLP tripples.I Have 40-10's with a 48/36 Helix and 15mm rollers,I bought these things from some other posts that i read, but can't seem to find any posts on where to start with the actual setup. 
ask turk .......
red primary spring, shoulder bolt with 5 washers, middle long bolt with 1 washer tip empty, try it and see where your rpm is and report back. I would use a red secondary spring at 90 with that helix.
You may be able to use a small bolt in the tip as well if your over revving, I have done set ups both ways with helix close to what you have there, and with 50/40,50/42 but it all depends upon brand helix used, snow conditions and your weight, how good your engine is tuned in as to what your rpm will be, youll be close anyways
You may be able to use a small bolt in the tip as well if your over revving, I have done set ups both ways with helix close to what you have there, and with 50/40,50/42 but it all depends upon brand helix used, snow conditions and your weight, how good your engine is tuned in as to what your rpm will be, youll be close anyways
Last edited:
We used to run
48/40 advantedge
5 grams shoulder & 4 tip
red hc spring
green secondary at 60
I had good luck running a more aggressive helix with those pipes.
48/40 advantedge
5 grams shoulder & 4 tip
red hc spring
green secondary at 60
I had good luck running a more aggressive helix with those pipes.