I decided to drop the rear suspension to replace the slides, grease up and inspect everything. This is the first time taking this apart so it was a learning experience. Good thing I did it alone cuz if it were on video it would have been very entertaining. Word to the wise, if you take a bolt out of one side without loosening the other side it will just spin.
Anyhow, I have two issues I cant figure out. First being I have two outter rear axle wheels that need replacing. I got the open axel wheels however they are they do not fit correctly. The wheel with on the nut side does not fit on axle. It is about 3/8 off (Yes they are the right part #). From what I can see if I trim the outter collar 3/16 on each side they will fit correctly. Is this normal?
Secondly, I have a bad bearing on one of the two small wheels on the top. I removed the retaining ring but that wheel does not budge. How do you get that off?
Maybe I'll video the install....
Thanks in advance.
Anyhow, I have two issues I cant figure out. First being I have two outter rear axle wheels that need replacing. I got the open axel wheels however they are they do not fit correctly. The wheel with on the nut side does not fit on axle. It is about 3/8 off (Yes they are the right part #). From what I can see if I trim the outter collar 3/16 on each side they will fit correctly. Is this normal?
Secondly, I have a bad bearing on one of the two small wheels on the top. I removed the retaining ring but that wheel does not budge. How do you get that off?
Maybe I'll video the install....
Thanks in advance.