Hey guys,
I bought a 99 SRX 600 last Feb. This is my first sled and I am a complete noob. I am just about to clean the power valves to get her ready for the winter. However, I noticed that the little tab that is supposed to be on the top of the cable holder (where it meets with the valve assembly) is actually on the bottom.
From my understanding this tab is supposed to be on the top. So my question is whether I can just flip the valve assembly over when I reinstall them or not. I am not fimiliar with the power valves at all so I dont know if they can fit either way or just one way.
Like I said, I dont know much so any information would be helpful. I have read the write ups in the tech section.
Thanks
I bought a 99 SRX 600 last Feb. This is my first sled and I am a complete noob. I am just about to clean the power valves to get her ready for the winter. However, I noticed that the little tab that is supposed to be on the top of the cable holder (where it meets with the valve assembly) is actually on the bottom.
From my understanding this tab is supposed to be on the top. So my question is whether I can just flip the valve assembly over when I reinstall them or not. I am not fimiliar with the power valves at all so I dont know if they can fit either way or just one way.
Like I said, I dont know much so any information would be helpful. I have read the write ups in the tech section.
Thanks
Flip the housing, and keep the valve the same.