servo pv cable routing

S

srx4life

New member
Joined
Dec 16, 2007
Messages
58
Age
43
Location
iroquois falls Ont, Canada
can somebody please post a picture of their cables hooked into the servo motor for a 2001 srx 700. I have seen and read the proceedure in the tech pages but find that it is somewhat confusing. A picture would tell a thousand words in this case.
 
here is a few shots of my 98 srx. if you look inside of the cover you will see 1,2,3 for the cables.
 

Attachments

  • engine 1 (3).jpg
    engine 1 (3).jpg
    386.9 KB · Views: 14
  • 100_0453 (2).jpg
    100_0453 (2).jpg
    288.9 KB · Views: 11
  • head shot.jpg
    head shot.jpg
    241.8 KB · Views: 5
Last edited:
I dont mean to hijack the thread, but does it matter if they are not in that order. I am in the process of cleaning my power valves for the first time and realized that the pto side valve and middle valve are switched. I didnt notice this before when i rode it a little last year. It ran good and seemed to have a lot of power, but then again it is my first srx. Regardless i am going to put them back in the right spots.
 
Ramrod said:
I dont mean to hijack the thread, but does it matter if they are not in that order. I am in the process of cleaning my power valves for the first time and realized that the pto side valve and middle valve are switched. I didnt notice this before when i rode it a little last year. It ran good and seemed to have a lot of power, but then again it is my first srx. Regardless i am going to put them back in the right spots.
Click to expand...
i shouldn't really matter,there both the same lenght cables,but thats how yamaha has them routed and how i do it...
 
You must log in or register to reply here.


Back
Top