Transfer rod help

Yamidude59

New member
Joined
Feb 19, 2008
Messages
980
Age
36
Location
Jackson Wi
figure i would get a wide amount of opinions here... i got bender tc3 t-rods installed and it appears there is a 50/50 gap when i am not on the sled and the gap goes to about a 60/40 or 70/30 when i am on it, These rods are mounted in the rear holes on my short travelled 01 srx, they are longer then the stock t-rods that came off of it, i'm beggining to think the guy who sold me these had lack of knowledge of what they were.

Is it a bad thing to have that gap where it is now with me not on the sled? i'm i loose suspension performance like this? i got really irritated when i noticed this after install.

Thanks for any help

Joe
 
1inch gap on top/no gap on the bottom when off the sled is good.If there is a gap on the bottom when off the sled you will have alot of weight on the skis makeing them dart hard in certain trail conditions when you have let off the throttle.Add Washers or the proper shims and tune them to your peferance.
 


Back
Top