PV setting time

R

Ride.Race.Live

New member
Joined
Nov 4, 2008
Messages
616
Age
36
Location
Canada Ontario
Ok so i took out all my cords off the servo motor, and im not sure in which order they go in...

i tried looking at the pic but im not 100% sure...

do they just in order from 1-3 with the open slots? from inside to out.

or is there a different order?

thanks!
 
Top cable is #1 and goes to the most inside, middle cable #2 goes on last to the outside, and #3 goes in the middle. Hope that helps.
 
awsome thanks guys!! exacly what i was lookin for...

wierd i didnt find that post by you daman when i did a search.. guess i missed it...


Thanks again!!!!
 
Any where to get em free? most info on the manuels are on this site.. just the trick is to find the right topic your looking for.

Appreciate the help though thats for sure!!!
 
Ride.Race.Live said:
Any where to get em free? most info on the manuels are on this site.. just the trick is to find the right topic your looking for.

Appreciate the help though thats for sure!!!
Click to expand...
I have a PDF '00 to '02 if you want it,,shoot me your email..
 
My servo pulley has two holes to put the ferrule in. Which holes do i use if both holes are at the bottom of the servo. The forward or aft. There is not much adjustment on the adjusting screws. They are almost all the way in. Is this normal. Any pics to show the hole and what ferrule goes where. Thanks alot....
 
Sanka said:
My servo pulley has two holes to put the ferrule in. Which holes do i use if both holes are at the bottom of the servo. The forward or aft. There is not much adjustment on the adjusting screws. They are almost all the way in. Is this normal. Any pics to show the hole and what ferrule goes where. Thanks alot....
Click to expand...
when you say ferrule you mean pv cable end? i guess i don't under stand what your asking??
 
The top cable goes closest to the servo on the clock wise side, then the bottom one goes next on the counter clock wise hole, and then the middle cable goes on last on the clock wise hole.
 
I believe thats what i'm asking. On the servo pulley there are three slots for the cables to fit into. In order to get the cables into these slots the cable ends need to slide through the pulley opening. There are two (holes) pulley openings that the cable ends can slide through. With cable goes into which hole in the pulley? I hope this is clearer.
 
You must log in or register to reply here.


Back
Top