cougar1985
New member
i got my 2000 xcr suspension friday. had to order new shocks and a couple of other small things to complete.was on the jb suspension site and was studing the exta 10 mounting ,they used a 97 polaris sed for info.if i understand it correctley i use those measurements to locate the holes on my sled ?
braindead1684
Member
Ya you should have Driveshaft to hole measurements and tunnel to hole height.
cougar1985
New member
yes ,thanksbraindead1684 said:
cougar1985
New member
the big question is what to do about mounting ,what to use?ive figured the skid is approx 2 inches narrower than the original ,theres no problem with bracing as the rear is reinforced allready and the front i can move the original one im sure.what should i used as spacers?3/8 inside diameter pipe or as suggested by jb suspension get the polaris tunnel brackets or should i get the fast mounting kit if it will work?im going to remeasure again then drill the mounting holes but im really not sure how to make up the 2 inches.