Sly72
New member
Looking for guidance on clutching from the clutching gods (Turk) (I've looked through the tech and haven't found anything)
I have a 97 SX 700 it's bone stock except for a bender race can (slip on).. I'm over revving at 9000 RPM.. I've been told that a good set up would be 3.6 grams on the inner and outer rivets and to go with a used RX-1 helix.. this should bring me around 8250-8350 rpm's?
Any input will be greatly appreciated!
I have a 97 SX 700 it's bone stock except for a bender race can (slip on).. I'm over revving at 9000 RPM.. I've been told that a good set up would be 3.6 grams on the inner and outer rivets and to go with a used RX-1 helix.. this should bring me around 8250-8350 rpm's?
Any input will be greatly appreciated!
swmichsx
New member
use turks set up from the tech page. i hear it is dead nuts on!!!!!!!!!!!!