02 Viper throttle problem

A

ArcticWolf 24

New member
Joined
Nov 16, 2008
Messages
7
Age
33
Location
Cape Breton, NS
Can be driving along fine at any RPM and sometimes (not every time) when I let off the throttle and then hit it again the engine doesnt react to the throttle. I have to let it idle right down to about 2000RPM (basically stop) before it will recognize the throttle. any suggestions?? or anyone had this problem??

today I cleaned the carbs (floats seemed to be working good) , power valves are clean, and clutches all cleaned, and I tried unhooking the throttle override with no luck.

Thanks, :o|
 
Did you unhook the throttle override and connect the two connectors together to bypass it? The two connectors on the wire harness side need to be connected to each other for bypass.
 
crewchief47 said:
Did you unhook the throttle override and connect the two connectors together to bypass it? The two connectors on the wire harness side need to be connected to each other for bypass.
Click to expand...
thanks a bunch, I switched the wires and it works perfect now :nos:
 
Your throttle cable is likely too tight and is activating the TORS. Sounds like you bypassed it and the sled runs fine. Remember that the TORS is a safety device. Better to run with it enabled if you can.
 
You must log in or register to reply here.


Back
Top