Getting ready to put a 1.25 ripsaw in 02 viper. I dont plan on studding. Do I need to remove the tunnel and front exchanger protectors so its like an 04?
racerguy
New member
I had to cut the lug down on mine where the protectors are, was able to use a side cutters and took about 1/8th to a 1/4 off in those spots 
Mine doesn't rub on the tunnel protectors at all.
Since I don't have studs I removed the front protectors with a Dremel.
It probably will rub if you don't, but some leave them there and let the track wear by itself.
Since I don't have studs I removed the front protectors with a Dremel.
It probably will rub if you don't, but some leave them there and let the track wear by itself.
wifesviper
New member
I have a 2002 viper with the ripsaw and it is noyched to clear the tunnel and front cooler.The traction is really goodracerguy said:I had to cut the lug down on mine where the protectors are, was able to use a side cutters and took about 1/8th to a 1/4 off in those spots
Ok, thanks guys. Sounds like I need to start cutting those front protectors out before I go any farther.
Dont remove the protectors, you will regret it!yamirules said:
On the ripsaw track, just clip the small teeth off the lug of the track inline with the windows. This will give you ample clearence and doesnt hurt the track!
I know you dont plan on studding, but who really knows the future??
just put it on and let it wear in. will not hurt it at all. kirkswims is that way and we have had no problems with it.
Dave M
New member
Clip the track... does not take long..