ssian
New member
My Hood on my sxr is not fitting around the front right side panel up front, if i force it it will go together but will pop out when i let go. Any one else have this problem?
ssian
New member
up to top
Check you hood hinges even for slight bending.
Do you have aftermarket pipes or something else installed that will prevent the hood from closing properly?
Do you have aftermarket pipes or something else installed that will prevent the hood from closing properly?
ssian
New member
no aftermarket stuff, hinges look ok.
T.S.U.Filmz
Member
What part of the belly pan front by the bumper or back by the rubber
ssian
New member
it is like the front right side
T.S.U.Filmz
Member
Ok loosen the hindges so there snug and wont move when you open the hood. Then tap on the hindge to adjust. Keep adjusting till you get the fit the way you want.
Did you loan your sled out ,, or may you have hit something to tweak it?
ssian
New member
no
does not look like any damage, i never let anyone use the sled, to me it is like the heat off the exhaust has made the right side sag.
\
does not look like any damage, i never let anyone use the sled, to me it is like the heat off the exhaust has made the right side sag.
\