Just received my pipe install kit from bender and the jets they sent me are all the same size 165 ...I called them and they said this is what they advise..It seems every post in this forum contradicts that..any idea why?
tedgoesfast
New member
turk would know
Did you get the head mod done? I think it is possible to run the same jets across the board with the mod. Do a search on the head mod
Nope no head mod. I even asked if I needed it since all the jets they sent were the same size and they said no only if it's an 04.
02ViperMtn
Member
did you get the opticool head gasket? I think you need that and the rear exchanger. What about the other jets? Did they send those or recommend certain ones? I am interested in finding out what people say about jets. I don't know what mine our because the pipes and jets were done by previous owner.
I did get the opticool head gasket and the rear heat exchanger...they told me they have adjusted the size of the jets they recommend over the years to allow for the degraded fuel available..they sent me just 3 jets, all 165, so I guess it will be my starting point.
mopar1rules
Active member
off my bender installation sheet.....165 mains if good premium, otherwise 167.5 mains, and 52.5 pilots if good premium, otherwise 55 pilots, 1-7/8 turns on fuel screws and i can't remember the needles right now. will post that info when i get home and can look at the sheet. this is good for 0-2000ft.
Thanks , just looking to do it right the first time.
mopar1rules
Active member
just checked the bender sheet, position 4 for the needles......that's clip in 4th groove (2nd closest to the pointed end), w/both shims underneath.