Exciterfan
Member
Well I was just putting the SXR700 away after doing some clutching adjustments and had her up on the track stand clearing the snow out when I sensed a shudder and then BANG...... The track blew.
It took out my 2x4 track stand and sent one piece 100 ft. (over the car thankfully) and into the bush!! Glad I wasn't standing behind it.
The track was studded but it didn't seem to let go at a stud???
The front heat exchanger looks like it had seen a stud before (gouge) but it didn't look like a fresh wound and so far no leaks that I can tell. I might find another exchanger in better shape and do a swap while I have it all apart. Anybody have one??
It was running so well and I had the clutching dialed right in.
Oh well, into the shop it goes.
It took out my 2x4 track stand and sent one piece 100 ft. (over the car thankfully) and into the bush!! Glad I wasn't standing behind it.
The track was studded but it didn't seem to let go at a stud???
The front heat exchanger looks like it had seen a stud before (gouge) but it didn't look like a fresh wound and so far no leaks that I can tell. I might find another exchanger in better shape and do a swap while I have it all apart. Anybody have one??
It was running so well and I had the clutching dialed right in.
Oh well, into the shop it goes.
I FOUND A BIG HOLE IN THE TRACK ON MINE . FROM STUDS 
SO I DID NOT CHANCE IT I PUT ON A NEW ICERIPPER 1.25 . NOW I CAN MOVE INSTED OF SPINNING
SO I DID NOT CHANCE IT I PUT ON A NEW ICERIPPER 1.25 . NOW I CAN MOVE INSTED OF SPINNING
xsivhp
Active member
^^^ X2
Good luck with the heat exchanger - they are A LOT of work to swap!
Good luck with the heat exchanger - they are A LOT of work to swap!
bluebandit98
New member
yea they are a hell of a project to change i was gunna do one then i had it welded an it still ended up leakin so i jus bought a hole nother chassis otherwise i was just gunna part the whole thing out and start over