Got codes?

[ViperXC]

Went out riding today and eventually noticed my warning light. The warning light and temp signal are flashing together 8 times then a pause. It cycles this continuously but the sled seems to run fine so not sure what it could be. Hand warmer wire got pulled loose but don't think that would cause this to happen. I can't think of anything else that happened out of the ordinary today. Called the dealer and they are looking into the code. It is a 2002 Viper. Was just wondering if anyone else has seen this and know what is causing the code. Thanks

 

[daman]

U shure it's 8? not seeing that i see a 7.

 

[ViperXC]

I believe it is 8 but what does 7 mean?

 

[daman]

not showing a code 8...

Servo issue...any problems there?

 

[daman]

check your wires going to the temp senser for broken off or bad.

 

[ViperXC]

Not sure, It seemed to run fine but the PV servo came to mind since I couldn't think of much that may be connected to the warning light. But why would the temp light blink with it if it is the servo error?

 

[daman]

see my above,also check/test thermo sensor,i can post that if needed.

 

[ViperXC]

If you want to post that, I would appreciate it Daman.

 

[daman]

Ok use this meathod to test but use this spec for your senser.

but first look at the wires you may have a broken one,look it over good,don't worry about your servo right now,check that other stuff.