SRX Connecting rod length?

[sideshowBob]

Any one know the connecting rod length on the SRX/Viper tripples?

 

[rellikclo]

Just a question for ya i know the rod and crank assembly are usually sold as one and are pressed assembly and should be taken apart and reassembled by someone who has the equipment and knowledge(not saying you don't know) just my .02 i know the stroke length is 62mm measured as factory spec if this helps..

 

[sideshowBob]

Looking for the connecting rod length for port timing calculations...haven't got a crank to measure thats not in an engine right now.

 

[harness racer]

I Got A Rod On The Bench Ill Measure It After Work , C/c I Assume Is Ok

 

[9801srx]

just checked one it 124mm c-c .

 

[sideshowBob]

I Got A Rod On The Bench Ill Measure It After Work , C/c I Assume Is Ok

Centre to Centre is what I need. Thanks

 

[sideshowBob]

just checked one it 124mm c-c .

Great Thanks!

 

[mopar1rules]

looked in my marshall distributing catalog and it says 125mm......not 124mm. i remember measuring up one a while back and it was right around 125mm.

 

[9801srx]

looked in my marshall distributing catalog and it says 125mm......not 124mm. i remember measuring up one a while back and it was right around 125mm.

mopar1rules is correct the c-c on the rod is125mm not 124mm . not sure how i f$%ked that up but i remeasured when i saw this post and got 125. sorry for the mix up.

 

[sideshowBob]

mopar1rules is correct the c-c on the rod is125mm not 124mm . not sure how i f$%ked that up but i remeasured when i saw this post and got 125. sorry for the mix up.

No Problem!
Thanks everyone!