Simons cpr instructions

B

BIGJOEVIPER

New member
Joined
Oct 14, 2009
Messages
10
Age
63
Location
Clio, MI
I bought a set of Simons CPR triple pipes for my viper. Anyone have a copy of the instruction sheet for proper installation.
 
what are you looking for. I dont have any instructions but i do have the jetting that was su by jeff. It was bought by me this way but i was told its right by the guys on here. I have a 04 viper s.
 
super1c said:
what are you looking for. I dont have any instructions but i do have the jetting that was su by jeff. It was bought by me this way but i was told its right by the guys on here. I have a 04 viper s.
Click to expand...
I bought the jet kit from him but he didn't send me insructions on which cylinder gets what jet and needle clip positions. also wanted to make sure I put heat tape in the proper areas.
 
Here is what im running. Im also running v force 3 reeds and heavy hitter clutch kit (I'm still learning about that). My jetting is as followed:

PTO side (clutch) Main 160, Pilot jet 47.5, Clip 4th ring both washers on top.
Center Main 160, Pilot 47.5, clip 4th ring both washers on top.
MAG ( exhaust side) Main 162.5, Pilot 50, Clip 4th ring both washers on bottom.

Not sure if thats what your running but this is what i have. I have a feeling it runs rich by the looks of the plugs but i will have to see. I'm going to start where im at and aee how it goes. I do a lot of river riding in low snow conditions so rich might not be a bad thing. Hope it helps
 
Thanks, this is what I was looking for! Finally talked to Jeff Simons and this is what he told me to do.

PTO and Center, Main 160, Pilot 50, Clip 4th - washer on top and bottom.
Mag, Main 162.5, Pilot 50, Clip 4th both washers on bottom.
Mixture screws 2.5 turns out.

Thanks for your response.

Joe
 
You must log in or register to reply here.


Back
Top