Clutch help
I have a sxr 700 00 with 51/43 green spring, stock primary 2.72 gears slp can 1.25 track. I weigh 220. It takes just about 3800 will turn 9000 wot. What weights should i run or just add more to the ones I have. I have to look to make sure what weights I have. I am open to a totally diff weights, set ups for better performance.
1.72 gears sorry not 2.72
I have a sxr 700 00 with 51/43 green spring, stock primary 2.72 gears slp can 1.25 track. I weigh 220. It takes just about 3800 will turn 9000 wot. What weights should i run or just add more to the ones I have. I have to look to make sure what weights I have. I am open to a totally diff weights, set ups for better performance.
1.72 gears sorry not 2.72
Last edited:
SWEDE
New member
You need to put 4.5 gram rivets in the inner holes in your flyweights this should help bring you down to 8500 rpm's were you should be.The stock weights are good for all around riding, I'd try that first.Wrap your secondary at 60-70 twist.
Ya that what i am at 60deg. Ya I have 8ch weights. They are loaded all ready with what I don't know.
Last edited:
SWEDE
New member
Not sure about those weights, mine has 8df-10 weights and that is what my suggestion is based upon, but you are overevving alot.It sounds like that sled has been played around with.Maybe someone will chime in about those weights and if they can work ok for you.Remember to always tune rpm's with the primary clutch, this works best.
I hope some one has some pointers for me. I also have 8cr weights
Last edited:
SWEDE
New member
Go on the technical pages and under clutching look at the weight section.It gives profiles and weights in grams, I'd compare what you have there to the 8df-10 weights to get you in the ball park weight wise.You may end up being better off finding some 8df-10 weights,and put 4.5 gram rivets in them.8dn-10 or 20's would work good also.
700triple
Member
What SWEDE says is good. 8CR should also work with that 51-43. And you will want to twist your secondary at least to 70-80. You dont want to rev over 8500, so play with the rivet in the primary to reach this.
What spring should I run as far as I know i have w-s-w. Turk told me it was to heavy.
Last edited:
daman
New member
change your inner rivet from 3.6 to a 4.5 gram,outer should be 4.5 already,
get a rx-1 helix & run it at 60 degree wrap with stock springs,she'll fly
get a rx-1 helix & run it at 60 degree wrap with stock springs,she'll fly
daman said:change your inner rivet from 3.6 to a 4.5 gram,outer should be 4.5 already,
get a rx-1 helix & run it at 60 degree wrap with stock springs,she'll fly
Run my 8ch. Or 8cr
daman
New member
stock weights....