teamred
New member
I'm installing a pro mountain skid from a 05 viper in my 02 short track viper. Already had the 121 extended to a 144 so I have the tunnel extension, heat exchanger and drop brackets. Anyone have the new mounting locations or any other tips?
Give me a few minutes as this was asked on here once before and I posted up the measurements. I have all bolt locations for the 05 Viper Mtn that I personally measured right off my sled.
EDIT: From my post, post #9 here, http://www.totallyamaha.net/forums/showthread.php?t=62986
From the flat back side of the drive axle to the center of the front mount - 11 11/16"
From the inside top of the tunnel down to the center of the front mount- 5 9/16"
From the center of the front mount to the center of the rear mount- 31 5/16"
From the inside top of the tunnel down to the center of the rear mount- 7 5/8"
EDIT: From my post, post #9 here, http://www.totallyamaha.net/forums/showthread.php?t=62986
From the flat back side of the drive axle to the center of the front mount - 11 11/16"
From the inside top of the tunnel down to the center of the front mount- 5 9/16"
From the center of the front mount to the center of the rear mount- 31 5/16"
From the inside top of the tunnel down to the center of the rear mount- 7 5/8"
Last edited:
teamred
New member
Thanks SXlover, measurements were right on, skid dropped right in. Thanks to sandrews for the great skid and prompt shipping. TY Rocks!!