just picked up these pipes this morning off craigslist for cheap. also got some onlin shocks and a heel clicker set up. i will have to revalve and powdercoat the shocks before i use them i will also high temp powdercoat the pipes after i use them on my 98 first i want to test them out. what do you think will work best for a silencer i have a new stock a bender can and a dyno port can. also what rpm have you run these at.
Attachments
valin
Active member
8350 rpm. I didn't realize they built the SRX pipes to run into a stock can also. I'd say run either stock or Bender.
rx1jim
New member
What did you pay for the Ohlin shocks? Just wondering what is considered a reasonable price for the front set. Thanks!
mopar1rules
Active member
heat tape the pipes too and run into stock can.
goody_700
New member
Waaay off subject, but I was reading this thread and I can't stop looking at Valin's avatar...sorry...
i payed 40 dollars for 1 need rebuilt and 125 for a good one still going to rebuild them. they sell between 200 and 350 in good shape.rx1jim said:What did you pay for the Ohlin shocks? Just wondering what is considered a reasonable price for the front set. Thanks!
valin
Active member
goody_700 said:Waaay off subject, but I was reading this thread and I can't stop looking at Valin's avatar...sorry...
I get that alot
