ottawaair
New member
Just curious what brand belts you guys are using.
Also recomendation on stud length for 1 1/4" x 136 ripsaw.
Also recomendation on stud length for 1 1/4" x 136 ripsaw.
2 new ??'s
- Thread starter ottawaair
- Start date
daman
New member
Most here run OEM only...ottawaair said:
007redline
New member
yep
Yamaha OEM tried alot of good aftermarket belts and for some reason they never hold up as well as the OEM...
Yamaha OEM tried alot of good aftermarket belts and for some reason they never hold up as well as the OEM...
ottawaair
New member
I read that yamaha belts are quite hard, which is why they last so long, but that hardness also causes a lot of slippage. the 8DN anyway. I have always used oem belts also but was just wondering about others.
staggs65
Moderator
slippage is from a poor clutch setup
yamyrider
Active member
I oly run OEM 8DN belt in my little sxr700 red head......I have been in radar runs and get 116MPH with the stock belt. I am in the 120's for top speed with no slipage.
I would not trust any other belt in my sled.
I would not trust any other belt in my sled.
ottawaair
New member
Hartmans website recommends using a carlisle ultimax, that is why i'm asking. Maybe that is what they sell??