Found in SRX700 airbox, what is it?

M

mxjeff

New member
Joined
Dec 30, 2009
Messages
40
Age
50
Location
Big Lake, MN
I recently bought a 98 SRX700. This beauty has a Bender exhaust can, Bender cold air kit, Bender clutch kit, Bender transfer rods. Upon removal of air box for carb cleaning I found this in the air box, it has a line attached that comes from the overflows on the carbs and a bigger line that just goes down between the carbs, another bigger line that terminates in the air box, one more line that comes off the last carb top cover on the right. Any idea what it is and how to adjust it? The sled runs great uo until 1/2 to 3/4 throttle thens bogs down bad. Thanks for any help.
 

Attachments

  • carb thing.jpg
    carb thing.jpg
    46.8 KB · Views: 9
looks like a tempa flow type system, that is suppose to create a vaccum on the float bowls to lean it out for you at altitude or warm temps. i hate them, and would recommend taking it off of there. just rejet for the cold air kit.
 
mopar1rules said:
looks like a tempa flow type system, that is suppose to create a vaccum on the float bowls to lean it out for you at altitude or warm temps. i hate them, and would recommend taking it off of there. just rejet for the cold air kit.
Click to expand...

X2

IMO:

Unneeded complexity on a SRX.
 
Thanks!!! Any ideas on where to start for jetting for the cold air kit? It's pretty low elevation and cold here!!!
 
There's a top horizontal piece with some foam on it,doesn't look like stock (maybe modified?) and no vertical dividers.
 
Definitely get that thing out! I put a Vari-flo on my SRX yrs ago (after seriously researching and reading everything I could about it) It created nothing but headaches. The dial is still on to remind of what a POS it was. I would also try and get your airbox back to stock and just play with your jetting.
 
Here's what it looks like, the foam sits on top of this piece and seals it to the hood for the cold air intake. Underneath this piece it's totally open to the carbs, no horizontal or vertical pieces.
 

Attachments

  • 100_1320.JPG
    100_1320.JPG
    76.6 KB · Views: 4
as near as i can figure that must be what the cold air instructions say to do to the box, cause every one ive ever seen with the cold air kit, mine included, is just like yours, gutted with the extra slots cut into the top
 
i would suggest putting part # 19 on the microfiche back in there and leaving part #'s 21 & 22 out. then run 42.5 pilots (stock), w/fuel screws @ 1-1/2 turns out, needles w/clip in middle postion & both washers underneath the clip, and 152.5 pto & center and 155 mag. this should be fine for 0*F. for -20*F riding, i would suggest 155 pto and center and 157.5 for mag. these will be safe ball park starting points. remember, these specs i gave you, is with the tempa flow system off the sled, carbs vented to atmosphere, and part #19 on the microfiche, back in the airbox, w/part #'s 21 & 22 out.
 
You must log in or register to reply here.


Back
Top